Jdc-electronic-sa Skywatch Aero Manual do Utilizador descarregar pdf (Página 8)

Connecting to the station

Once the SKYWATCH AEROlog software is installed, the

rst step is to connect up to the AERO station: click

on “Connect” menu, then choose between “Auto” and

“Manual”.

The “Auto” mode scans all USB ports and connects up

to the rst station it nds. The “Manual” mode allows

the user to choose which port is to be connected to.

This mode is used particularly when several stations

are connected to the same PC. The desired port has

to be selected from a pull-down list, then click on the

“Connect” button. The port selected will be saved to

memory.

When the station is connected, the “Connected” status is displayed on a green background

in the menu bar.

Click on “Disconnect” in the “Connect” menu to disconnect.

SKYWATCH AEROlog software

SKYWATCH AEROlog software was developed as a user interface for conguration,

viewing measurements in real time and downloading of measurements recorded by the

station.

Installation of the software

If the computer is connected to the internet, double-clicking on the “setup.exe” le under

“AEROlog” on the CD initiates software installation. In the rst instance the installer

proceeds to analyse whether the PC has the necessary prerequisites for software use;

otherwise, the “.net” framework will be updated.

If the computer is not connected to the internet, the “.net” framework must rst be

installed by double-clicking on the “dotNet…exe” le in the “AEROlog” directory on the

CD.

USB driver

When the AERO station is connected to the PC by USB cable, a new virtual serial port

is installed on the computer. If needed, the driver is available on the CD in the “Driver”

directory. Before installing the driver, make sure you disconnect the station USB cable.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sem comentários

Jdc-electronic-sa Skywatch Aero Manual do Utilizador Página 8